Bluetooth Function; Using The Machine; Preliminary Procedures; Checking The Battery - ST MPST 84 Li 48 V1 Manual Del Usuario

"ECO" push-button
Pressing the push-button
fig. 12.H activates/deactivates
the "ECO" function.
The "ECO" function saves energy
when cutting grass by optimising the
travel speed and the rotation speed
of the cutting means to extend the
battery life. When the function is
active the icon fig. 12.J. lights up.
WARNING
We do not recommend the use
of the "ECO" function during
heavy cutting conditions (cutting
thick, high, wet grass).
Caution Icon
The icon fig. 12.E, if lit, indicates
failure to comply with safety
conditions or a possible malfunction
of the machine (see chap. 15).
Battery LED
The LEDs fig. 12.F,numbered
from 1 to 5 starting from the left,
normally indicate the battery
charge level of the machine, but
specific combinations of their
illuminated status provide some
information regarding machine
malfunctions (see chap. 15).
"Bluetooth" icon
The icon fig. 12.M lights up
when the machine and the data
exchange device are connected.
Controller and/or motor
over-heating icon
The icon fig. 12.N indicates
overheating of the electrical
components (see chap.15).
Transmission engagement /
disengagement lever icon
The icon fig. 12.O lights up when
the transmission is not engaged
(see par. 6.4 and chap. 15).
Operator on board icon
The icon fig. 12.P lights up
when the operator is not on
the seat (see par. 7.2.2).
Emergency push-button icon
The icon fig. 12.Q lights up when
the emergency push-button
is activated (see par. 6.7).

6.10 BLUETOOTH FUNCTION

The Bluetooth function, allows direct
wireless connection between the machine
and a device at a short distance.
The device must have the appropriate
app for data exchange installed, whose
instructions for use are provided separately.
The Bluetooth connection is
activated automatically when
the machine is started and the
connection with the device is
confirmed by the illumination
of the icon fig. 12.M

7. USING THE MACHINE

CAUTION
The safety regulations to follow are described
in chap. 2. Strictly comply with these
instructions to avoid serious risks or hazards.

7.1 PRELIMINARY PROCEDURES

Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.

7.1.1 Checking the battery

Before using the machine for the first
time after purchase, proceed to fully
charge the battery (par. 8.2.2).
Before each use, check the charge
status of the battery (fig. 12.F).

7.1.2 Seat adjustment

To change the seat position, loosen the four
fixing screws (fig. 13.A) and slide it along the
slots. Once the desired position has been
found, tighten the four screws (fig. 13.A).

7.1.3 Tyre pressure

Having the right tyre pressure is the main
condition for ensuring that the cutting-means
assembly is horizontal and mows evenly.
1. Unscrew the valve caps.
2. Connect a compressed air line with
a gauge to the valves (fig. 14).
3. Adjust the pressure according to the values
indicated in the "Technical Data" chart.
EN - 14