Anti-Scalp Wheels; Cleaning; Cleaning The Machine - ST MPST 84 Li 48 V1 Manual Del Usuario

NOTICE
If the battery charger is connected to the tractor
and the 5 LEDs (Fig 12.F flash at the same time,
it means that charging is not in progress. Check
the connection battery charger/electric mains.
NOTE
The energy consumption to maintain the
battery charged is very low and inexpensive.
NOTE
During recharging, all machine
functions are disabled, even if the key
is turned to the drive position.
WARNING
The battery fitted on the machine has been
designed and manufactured for this type of use,
therefore:
- do not disconnect or remove the batteries from
their housings;
- do not replace the batteries with non-original
ones;
- do not perform any work which is not mentioned
in this manual.
In the event a problem with the batteries,
please contact your Dealer.

8.3 ANTI-SCALP WHEELS

The different heights of the wheels allow
you to maintain a safe distance "H"
between the cutting-means assembly
and the ground (Fig. 25.A, Fig. 26.A).
Adjust the position of the anti-chipping wheels
according to how irregular the ground is.
SAFETY INSTRUCTIONS
This should always be performed on
both wheels, positioning them at the
same height, with the machine off.
a. For side discharge models:
To change the position:
1. Unscrew and remove the screw (fig.25.B)
2. Reposition the wheel (fig. 25.A) with
the spacer ( fig. 25.C) inside the
hole at the desired distance
3. Tighten firmly the screw (fig. 25.B)
in the nut (fig. 25.D).
b. For models with rear collection
To change the position:
1. Unscrew the nut (fig. 26.B) and
extract the pin (fig. 26.C);
2. reposition the wheel (fig. 26.A)
in the desired position;
3. reassemble the pin (fig. 26.C), making
sure the pin head (fig. 26.C) is facing
the inside of the machine;
4. Tighten the nut firmly (fig. 26.B).

8.4 CLEANING

Clean thoroughly following the instructions
below every time it is used.

8.4.1 Cleaning the machine

• Clean the outside of the machine
washing the plastic parts of the bodywork
with a damp sponge using water and
detergent, being careful not to get the
electric motors, the battery and the
electrical system components wet.
• To reduce fire hazards, keep the motor
and the battery compartment free of
grass, leaves, or excessive grease.
• Lift the bonnet and clean with compressed
air any dirt or grass accumulating
on top of the battery pack.
• Keep the push button panel
free of dirt and debris.
WARNING
Never use high-pressure water or aggressive
liquids to wash the bodywork and electric motors.
8.4.2 Cleaning the discharge chute
(only for rear collection models)
If the discharge chute is clogged:
1. remove the grass catcher or the
rear discharge guard;
2. remove the grass cuttings; you can reach
them from the channel discharge opening.
8.4.3 Cleaning the grass catcher
(only for rear collection models)
1. Empty the grass catcher.
2. Shake it to remove grass
cuttings and soil residue.
3. Replace the grass catcher and clean
the interior of the cutting-means
assembly (par. 8.4.4-a) now remove
the grass catcher, empty and rinse it,
then place it where it can dry quickly.
EN - 21