Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USE
The injection pump and camshaft alignment pin (Tool 1) is
used to hold the camshaft in the correct position and allows
the cam sprocket to be loosened whilst maintaining the
position of the camshaft (always use an appropriate sprocket
holding tool to prevent damage to the pin).
Tool 2 & 3 are both crankshaft position locking tools and
whilst they work on the same principle they are different. Use
the appropriate tool unit for the vehicle as recommended by
the manufacturers' instructions.
Note:
A crankshaft pulley requiring the T10050 has its timing mark
aligned with a tooth where as a pulley requiring the T10100,
the timing mark is between the teeth.
Tool 4 allows the user to adjust the Camshaft drive belt
tensioner pulley.
Tool 5 is used to lock the tensioner in the retracted position to
make belt removal and fitting easier.
Tool 6 is used to lock the auxiliary belt tensioner in its retracted position.
Tool 7 the sprocket holding tool allows the user to hold the appropriate sprocket
whilst loosening its fixing without damaging the locking pins.
Tool 8 is a Camshaft hub puller and is required when dismantling the upper cylinder head.
It is used to remove the Cam to Cam gears so they can be timed to each other correctly.
Tool 9 is for removing and installing the balance shaft module.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
