Intended Use; Safety Advice - BGS technic 66200 Manual Del Usuario

for VAG 1.6 & 2.0L TDI Common Rail
TOOLS
1 Injection Pump / Camshaft Alignment Pin, to be used as OEM T20102, 3359
2 Crankshaft Pulley Locking Tool, to be used as OEM T10050
3 Crankshaft Pulley Locking Tool, to be used as OEM T10100
4 Tensioner Pulley Adjustment tool (2.4mm Hex key), to be used as OEM T10264
5 Tensioner Pulley Locking tool, to be used as OEM T10265
6 Auxiliary Tensioner Locking tool (3.9mm), to be used as OEM T40098
7 Sprocket Holding Tool, to be used as OEM T10051
8 Cam Sprocket Hub Puller, to be used as OEM T10052
9 Oil pump / Balancer Shaft Alignment, to be used as OEM T10255

INTENDED USE

This Set includes essential tools for timing belt replacement on 1.6 and 2.0 Common Rail TDI engines
and allows locking and adjustment of flywheel (crankshaft), camshaft, idler pulley .
Further information regarding the item and a list of suitable motors and models can be found on our
website: www.bgstechnic.com

SAFETY ADVICE

•
Do not use the set if any parts are missing or damaged.
•
Only use this tool for the purpose for which it is intended.
•
Never lay tools on the vehicle's battery. This may short the terminals together.
•
Be careful when working on running engines. Loose clothes, tools and other things can be caught up
in revolving parts which may lead to serious injuries.
•
Keep children and other unauthorised persons away from the working area.
•
Be careful when working on hot engines – risk of burn!
•
Remove the negative battery connection before repairing, so you avoid short circuits and that the
engine will not start unintentionally.
•
This manual is just brief information and will not replace a garage handbook.
•
Always consult specific service literature for information about torques, assemblies and
disassemblies etc.
•
After any successful maintenance and before starting the engine, you should rotate the engine for
two turns manually to check the new control time.
•
Turn the crankshaft in the normal direction (clockwise unless stated otherwise) and only at the
crankshaft itself, never turn the crankshaft by turning camshaft or another wheel.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Engine Timing Tool Set
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 66200
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed