12.2 Graphic Display
12.2.1 Luminous segments indicating the pump setting
The pump presents nine setting options that can be selected with the
The pump settings are indicated by six luminous segments on the display.
12.2.2 Key for selecting the pump setting
Whenever the
key is pressed, the pump setting is changed. A cycle consists of pressing the key ten
times.
12.2.3 Display Operation
The Evosta3 circulator has a display that is able to show the following values.
The values are shown in sequence for 3sec. Once the viewing cycle is ended, the display switches off and
only the operating mode LED remains lit.
If the selection key is pressed within 10sec, the display performs 6 viewing cycles, then goes into stand-by.
If the key is pressed again within 10sec, the display performs 11 more viewing cycles to allow a greater reading
time.
Figura 10: EVOSTA2d Display
Height of the selected curve (1-2-3)
Instantaneous power absorption in Watt
Instantaneous head in feet
Instantaneous flow rate in gallon/minut
ENGLISH
14
key.