Intended Use; Safety Information - BGS technic 6683 Manual De Instrucciones

Flaring Tool for 4.75 mm (3/16") Brake Pipes
PARTS............................................................
1 Combination spanner 10 mm
2 Combination spanner 17 mm
3 Clamping jaws / basic device with inspection hole
4 2-component handle
5 Flaring grease
6 Stop screw
7 Flaring screw
ATTENTION
Read these operating instructions carefully and observe all safety instructions before using the
product.

INTENDED USE

This tool serves to produce flare type DIN ISO F on brake pipes with a diameter of 4.75 mm (3/16").
The flaring tool is very handy and can be used on the vehicle without having to disassemble the brake
pipe.

SAFETY INFORMATION

• Repairs on brake systems may only be carried out by trained persons that have experience.
• Only use the tool set for the purpose for which it is designed.
• Do not use the tool if parts are missing or damaged.
• When using the product, be sure to wear the correct safety clothing and take protective
measures.
• The use of protective gloves, safety glasses and safety shoes is recommended.
• Check the condition of the tool regularly and replace damaged parts.
• Always keep the thread clean and well oiled. Careful maintenance guarantees the operational
readiness and longevity of the tool.
• Before use, familiarise yourself with the correct use of the tool to be used, taking into account the
necessary safety measures.
• Always follow the instructions of the vehicle manufacturer.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6683
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed