Grundig GDS 2460 B Instrucciones Para El Usuario página 14

5 Installation Of Appliance
• The bolts and dowels provided
are suitable for brick walls. For
other construction material (e.g.
drywall, plate, porous concrete),
suitable fixing dowels and nuts
shall be used.
(Figure 6)
Draw a mid location line from the
ceiling perpendicular to the lower
edge of the hood ().
Paste the installing
provided within the accessories on
the surface where the hood is to be
mounted. In doing this operation,
observe the mounting height of the
hood (Page 14).
There is a tab in the middle of the
flue connection plate. Place the
middle point of this tab on the line
that is drawn perpendicular to
the wall. In doing this operation,
adjust the hood according to the
maximum height (Page 10 / Figure
1). Mark the holes where the flue
connection plate will be mounted
with the help of a pen (Figure 6/a).
Drill the marked points with Ø6mm
drill and insert 2 plastic dowels in
the drilled holes (Figre 6/a). Fix the
flue connection plate to the wall
with 3,9x22 screws (Figure 6/a).
To assemble the hood body, you
can use the A, B, C, D Ø8 mm drill
on the assembly template, and
insert 4.8x50mm plastic dowels at
these points. (Figure 6/b).
2 piece 4.8x50 suspension screw
with a clearance of 5 mm between
the screw head and the wall (Figure
6/b).
(Figure 7)
1. Hanger Plate
2. Hanging Plate Connection
Screw
In order to install your hood to
the wall, loosen the screws on
the hanger plates mounted on the
motor cabin and pull them up, and
then fasten again (Figure 7 / A).
template
Turn on the suction glass of the
hood and remove the aluminum oil
filter (Page 13 / Figure 3).
A
CAUTION
Before drilling, ensure
that there are no power,
gas or water pipes in the
close proximity of the
drilling locations.
EN
ES
PT
DE
FR
DA
NO
SV
FI
RO
BG
PL
14