Hanging The Fan - Kichler Bead 54 Manual De Instrucciones

HANGING THE FAN

REMEMBER REMEMBER to turn off the power before you begin installation. This is
necessary for your safety and also the proper programming of the control
system. To properly install your ceiling fan, follow the steps below.
Step 1. Loosen two (one of each across) of the four screws from the ceiling Step 1.
mounting bracket, and remove the other two and keep for later use, then
release the ceiling mounting bracket from the motor assembly. (Fig. 4)
Step 2. Before attaching fan to outlet box (not included), ensure the outlet Step 2.
box is securely fastened to at least two points to a structural ceiling member
(a loose box will cause the fan to wobble). Pass the 120 volt supply wires from
the ceiling outlet box through the center of the ceiling mounting bracket.
Install mounting bracket to outlet box in ceiling using the screws and washers
included with the outlet box. (Fig. 5)
Step 3. Hook the motor body onto the ceiling mounting bracket as shown. Step 3.
You can now proceed with the electrical wiring of your fan. (Fig. 6)
Fig. 4
Listed Outlet Box
Ceiling Mounting Bracket
Flat Washer
Motor Assembly
Screw
Fig. 5
Motor
Assembly
Fig.6
54" Bead LED | 7
Ceiling Mounting
Bracket
Motor Assembly
Hook