Operation - Brandt AT1349X Montaje Y Modo De Empleo

Preparations for installation
1. Connect the power cable to the hood.
2. Remove the grease filter/s.
3. Remove, if installed, the charcoal filters (2, installed on
the sides of the suction motor)
Proceed with the preferred type of installation (see
"Installation on the bottom of the kitchen wall unit" or
"Installation on the side of the kitchen wall unit")
Installation on the bottom of the wall unit
4. Apply the drilling template on the bottom of the wall unit
and drill the holes for the passage of screws, for the drain
hole and for the electric cable.
Note: Repeat the drilling for the exhaust pipe and electric
cable also on the ceiling or on the back of the wall unit as
needed.
5. Install the hood with the screws. Proceed with the
adjustment of the drawer depth (see instructions under
"Adjusting the depth of the drawer").
Installation on the sides of the wall unit
6. Install the hooking rails on the sides of the wall unit with
screws.
Note: Attach the rails so that they are in line with the
lower and the rear edge of the wall unit.
7. Install the side brackets to the hood with the screws.
8. Slide the hood using the newly installed brackets on the
rails attached to the sides of the wall unit.
9. Adjust the position of the hood so that it is perfectly
adherent to the wall unit.
Note: To do this, loosen the screws that secure the side
brackets (see installation sequence 7) and screw them
back when finished.
10. Secure the hood with the screws. Proceed with the
adjustment of the drawer depth (see instructions under
"Adjusting the depth of the drawer").
Adjusting the depth of the drawer
11. Install the adjustment brackets and secure them with the
screws (not fully tighten).
Push the drawer into the desired position and tighten the
screws securing the adjustment brackets that will work as
"closing stop" for the drawer.
Proceed with finalizing the installation (see instructions
under "Finalizing Installation").
Finalizing Installation
12. Install an exhaust tube sufficiently long to reach the top of
the wall unit (recirculation version) or outside (ducted
version).
Perform also the cable connection to the power supply of
the house.
13. Install the charcoal filters if you decide to use the hood in
recirculation mode, otherwise cannot be used.
14. Reinstall the grease filter/s.

Operation

The hood is fitted with a control panel with aspiration speed
selection control and a light switch to control cooking area
lights.
a. ON/OFF light switch
b. Speed 1/OFF switch
c. 2-speed selection
d. 3-speed selection
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
52