Harbor Breeze LP8210LAZ Manual Del Usuario página 7

ASSEMBLY INSTRUCTIONS
4. Thread the downrod (C) into downrod support
of the motor assembly (A). Align the holes in
the downrod support of the motor assembly (A)
with the holes in the downrod (C) and install the
previously removed clevis pin. Secure clevis
pin with previously removed hairpin clip.
Tighten the two set screws in the downrod
support of the motor assembly (A).
WARNING
It is critical the clevis pin in the downrod support
is properly installed and the set screws are
securely tightened. Failure to do so could result
in the fan falling.
5. Position the blades (L) over the blade arms (K)
with threaded posts showing. Make sure the
bottom edge of the blades (L) are fully seated
against the blade arms (K). Install and tighten
the washer-head screws (BB) with fiber
washers (CC) to secure the blades (L) to the
blade arms (K).
Hardware Used
Washer-Head
BB
Screws
Fiber
CC
Washers
6. Attach blade arms (K) to the hub of motor
assembly (A) using screws (AA).
NOTE: Periodically check blade arms hardware
and resecure if necessary.
WARNING
To reduce the risk of personal injury, do not
bend the blade holders when installing,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between the rotating
blades.
Hardware Used
AA
Screws
x 15
x 15
x 10
7
4
C
A
5
CC
K
6
A
Lowes.com/harborbreeze
BB
L
AA
K