Allmand 725 Instrucciones De Instalación página 10

7
H
10. Install the stripped end of the blue wire (J, Figure
8a-b) with the new fork terminal into an open port of
Distribution block 2. If the wire is red, install wire into
Distribution block 1, and if the wire is black, install wire
into Distribution block 3. If a port is not open select a
larger port to install with another wire. To install in the
distribution block loosen the set screw for the port that
stripped end of the wire will be inserted in. Make sure
all the bare wire strands are in the port. Tighten the
set screw in the distribution block.
8a
Distribution Block 1
Distribution Block 2
4b
Distribution Block 2
Distribution Block
Connection Detail
10
I
J
Distribution Block 3
J
11. Loosen the screw on AC post 1 of 725 light relay 2 and
connect the fork terminal on the wire (K, Figure 9a-b)
leading from either Distribution block 1, 2, or 3 into the
post. Tighten down the screw onto the fork terminal.
9a
9b
725 Relay
Connection Detail
12. If replacing Zettler relay 2, locate the 12 AWG wire
(L, Figure 10a-b) that is leading from the relay to
light switches 1 and 2. If working from Zettler relay 1
locate wire from light switches 3 and 5. If working from
Zettler relay 3 on a 6-light unit locate wire from light
switches 4 and 6, and if working from Zettler relay on
a 4-light unit locate the. Remove the two screws (M,
Figure 10a), the 12 AWG wire, and buss bar (N, Figure
10a) from the top of the switches. Discard the buss
bar, and set one of the screws aside as it will be used
in Step 17. If replacing Zettler relay 2, re-install the
wire and screw onto light switch 1. If replacing Zettler
relay 1 go to light switch 5. If replacing Zettler relay 3,
on a 6-light unit go to light switch 4, and on a 4-light
unit go to switch 2.
725 Relay 2
K
725 Relay 2
K
www.allmand.com