Allmand 725 Instrucciones De Instalación página 9

4a
Distribution Block 1
Distribution Block 2
4b
Zettler Relay
Disconnection Detail
7. Cut off and discard the female spade terminal from
the wire that was connected to the Zettler relay. Strip
off the appropriate amount of wire insulation and crimp
a yellow fork terminal (F, Figure 5, Ref. 7) onto the
wire.
5
F
E
Distribution Block 3
Zettler Relay 2
E
8. Loosen the screw on AC post 1 of 725 light relay 1
and connect the new fork terminal on the wire (G,
Figure 6a-b) removed from either Zettler relay 1, 2, or
3 into the post. Tighten down the screw onto the fork
terminal.
6a
6b
725 Relay
Connection Detail
9. From the kit contents, locate and select the blue 10
AWG wire (H, Figure 7, Ref. 5) that matches the color
of the wiring from Zettler relay 2. For Zettler relay 1
select the red 10 AWG wire (Ref. 4), and Zettler relay
3 select the black 10 AWG wire (Ref. 6). Cut the
selected 10 AWG in half, and strip the ends of the
cut wires. On one of the cut wires crimp a yellow fork
terminal (I, Figure 7, Ref. 7) on one of the ends. Set
aside the other cut wire as it will be used in Step 16.
725 Relay1
G
725 Relay 1
G
en
9
English