Uline H -1027 Manual De Instrucciones página 11

PISTON REPLACEMENT
1. Remove screws and nut with 8 mm spanner wrench
and 4 mm Allen wrench. (See Figure 31)
2. Remove magazine assembly. (See Figure 32)
3. Loosen set screw with a 3 mm Allen wrench to unlock
the adjusting rod.
4. Slide linkage mechanism and adjusting rod
simultaneously from collar.
5. Loosen collar with a 3 mm Allen wrench to remove
the spring. (See Figure 33)
Figure 31
Cap
Figure 34
PAGE 11 OF 33
OPERATING INSTRUCTIONS CONTINUED
Figure 32
Figure 35
1-800-295-5510
6. Loosen screw with a 3 mm Allen wrench and remove
the block through the window.
7. Loosen screws with a 3 mm Allen wrench and
remove the cap. (See Figure 34)
8. Remove the piston assembly with a 10 mm spanner
wrench. (See Figure 35)
9. Remove piston and replace.
Magazine Assembly
Piston Assembly
uline.com
Figure 33
Spring
0421 IH-1027