Angelcare AC115 El Manual Del Propietario página 19

LOSS OF CONNECTIVITY BETWEEN THE PARENT UNIT AND THE NURSERY UNIT
• In the case of loss of connectivity, the first step is to bring the Parent Unit and Nursery Unit closer together
and make sure that both units are ON to restore the connection. If there is still no connection and no out-of-
range warning after the above has been done, then and only then should the re-connection procedure below
be done.
3
6
FALSE ALARMS
• Turn OFF the Nursery Unit.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the Sensor Pad measuring
at least 1/4'' (6 mm) thick and should have minimum dimensions of 13'' x 13'' (33 x 33 cm).
• Make sure the Sensor Pad is positioned as described under the setup requirements.
• You may need to increase the sensitivity, refer to Step 5.4.
ALARM WILL NOT SOUND
• Avoid contact with the crib when the monitor is ON.
• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement
from outside the crib.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
• You may need to decrease the sensitivity, refer to Step 5.4.
1) Turn Parent Unit OFF.
2) Turn Nursery Unit OFF and then turn it ON.
3) Press the Power ON/OFF button on the Nursery
4) Turn the Parent Unit ON. The Out-of-Range
5
5) Press and hold the Talk Back button on the
6) Press OK button on the Parent Unit. The Out-of-
The Parent Unit will display H1-H2 icon during the reconnection
procedure. The reconnection is successful if the Parent unit
shows the regular screen view.
Unit 4 consecutive times.
The Sensor Pad Indicator
Light on the Nursery Unit
will flash quickly in green
(indicates Nursery Unit is in
linking mode).
GREEN
icon should blink.
Parent Unit until a beep tone is heard.
Range
icon should blink faster to indicate
that the Parent Unit is in linking mode.
E
N
19