Angelcare AC115 El Manual Del Propietario página 20

NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP
• Check connections or change to another electrical outlet.
• Press the Nursery Unit ON/OFF button for 2 seconds to turn the Nursery Unit ON.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface out of baby's reach.
• Replace the batteries or recharge the Parent Unit.
STATIC, DISTORTION, INTERFERENCES (FROM OTHER
MONITORS, WIRELESS PHONES, WALKIE-TALKIES, ETC...)
• Rotate the Parent Unit or move it away from source of interference.
FEEDBACK (LOUD NOISES EMITTED FROM THE PARENT UNIT)
• Move units further apart (at least 10 foot [3 meters] apart).
• Decrease volume on the Parent Unit.
THE PARENT UNIT SCREEN IS BLACK (PARENT UNIT IS OFF)
• Turn the Parent Unit back ON by pushing and holding the power button.
• Replace the batteries or recharge the Parent Unit.
SENSOR PAD LIGHT INDICATOR FLASHING RED
(MONITOR IS BARELY DETECTING MOVEMENT)
• Make sure there is no bedding between the mattress and the Sensor Pad.
• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring or slat base, place a
hardboard between the crib base and the Sensor Pad measuring at least 1/4'' (6 mm) thick and should have
minimum dimensions of 13'' x 13'' (33 x 33 cm).
• Make sure Sensor Pad is positioned as described under the setup requirements.
• You may need to increase the sensitivity, refer to Step 5.4.
NO POWER
• Check or replace batteries.
• Make sure Monitor is ON.
NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP
• Check connections or change to another electrical outlet.
• Press the Nursery Unit ON/OFF button for 2 seconds to turn the Nursery Unit ON.
20