Levolor Roman Shades Instalación página 7

INSTALLATION
OUTSIDE MOUNT (OM)
Drywall Drywall
Bracket
Anchor Bracket
Anchor
Screw
Screw
STEP 2: INSTALLING THE BRACKETS
IMPORTANT: Use drywall anchors when mounting into drywall (not provided).
IMPORTANT: The rear of the brackets must be flush against a flat mounting surface.
Do NOT mount brackets on curved molding.
•
Pre-drill screw holes using a ⁄ " drill bit, using pencil marks as a guide.
1
16
•
Hold the bracket with the surface marked "Top" so that it is facing upwards and
then line up the pre-drilled screw holes with the holes in the bracket.
— Note: If using spacer blocks: Stack spacer blocks on the back side of the
installation brackets (see page 14 for additional details).
CAUTION: Do not use more than one spacer block. Using more than one
!
spacer block could cause shade to fall resulting in possible injury.
•
While holding the bracket in place, secure with screws, 2 screws per bracket.
•
Repeat for each bracket.
•
Use a level to confirm all brackets are level.
12
Cordless Lift Control
19-0050-030 Romans Install Guide-Cordless_F_070720.indd 12-13
OUTSIDE MOUNT (OM)
STEP 3: INSTALLING THE SHADE
•
Hang the curved front side of the headrail on the front lip of the brackets.
•
Rotate the headrail backwards toward the window until a snapping sound is heard.
This will let you know the shade is engaged in the brackets.
•
Install the included operating handle by snapping it onto the front of the bottom rail;
in case of a top-down/bottom-up shade, snap a handle onto the middle rail as well.
CAUTION: Do not use more than one spacer block. Using more than one
!
spacer block could cause shade to fall resulting in possible injury.
INSTALLATION
Front lip
Front Lip
Spring tab
Spring Tab
Headrail
Headrail
13
Cordless Lift Control
7/7/20 9:11 AM