Adjusting Alignment; Removing The Shade - Levolor Roman Shades Instalación

ADJUSTING ALIGNMENT AND FOLDS
To ensure the shade raises and lowers evenly, the roman bar clips on the back of the
shade may need to be adjusted. These clips are self aligning; however they can shift
out of alignment from time-to-time.
•
The shade should be adjusted to the fully lowered position.
•
Locate the cord route in the top of the headrail behind the shade.
•
On the back of the shade, adjust any roman bar clips by hand that are out of vertical
alignment with the cord location in the headrail.

REMOVING THE SHADE

In one motion forcefully push forward on the headrail until spring tabs on installation
brackets are fully depressed, then tilt headrail down to release headrail from bracket.
Note: Focus push force in the areas where the installation brackets are connected to
the headrail.
CAUTION: Hold shade firmly when removing. Failure to do so may result
!
in the shade falling and possible injury.
OPERATION | UNINSTALL
Corded Lift Control
17