Soundoff Signal mpover EMPS202KE Manual Del Usuario página 2

with Clear Duty® Technology
WIRE HOLE
LOCKNUT x2
STUD MOUNT - THREADED (SHOWN)
FORD GRILLE MOUNT - THREADED (SIMILAR, NOT SHOWN)
1.800.338.7337 / www.soundoffsignal.com
2
FIGURE 1
THREADED STUD x2
MOUNT SURFACE
QUICK MOUNT
SCREW MOUNT
INSTALLATION:
Stud Mount (Figure 1)
1. Pre-Drill per stud mount pattern indicated on page 11 (3") or per
2. Clean the surface as required.
3. Deburr hole as required.
4. Make wire connections and feed wire through the
FIGURE 2
5. Install light, inserting 2 studs into the 2 drilled holes.
6. Install 2 lock nuts onto studs behind mount surface.
Quick Mount (Figure 2)
1. Pre-Drill per quick mount pattern indicated on page 10 (4") or
2. Deburr hole as required.
3. Clean surface with supplied alcohol wipe.
4. Make wire connection and feed wire through the drilled wire
ADHESIVE SURFACE
5. Remove adhesive backer and align light into desired position.
Screw Mount (Figure 3)
1. Pre-Drill per screw mount pattern indicated on page 10 (4") or
2. Deburr and clean the surface as required.
3. Make wire connections and feed the wire through the
4. Install light with 2x Torx drive screws and hand tighten
FIGURE 3
TORX DRIVE SCREWS x2
the supplied mounting template (4").
drilled wire hole.
Hand tighten only until mount surface and light are
flush.
page 11 (3"). (Wire hole only).
hole.
Apply to surface and hold firmly for 30 seconds. CAUTION!
APPLY UNIFORM PRESSURE ACROSS FULL
FACE OF LIGHT.
page 11 (3").
drilled wire hole.
only until mount surface and light are flush.
mpower Spot 0121