Graco SNUGRIDE 30 Manual Del Usuario página 37

Lap/Shoulder Seat Belt Installation
Always review your vehicle owner's manual for specific
information about your vehicle seat belts.
There are three types of retractors: ELR (Emergency Locking
Retractor), ALR (Automatic Locking Retractor), and
Switchable (ELR switch to ALR). To determine your type of
retractor, follow these steps:
1. Slowly pull the belt out about halfway and
stop.
2. Let the belt retract back several inches.
3. Try to slowly pull the belt out more.
If the belt cannot be pulled any further,
it is ALR, ready to install your base. If it can
be pulled further, go to the next step.
4. Slowly pull the belt all the way out, and
then allow it to retract several inches. You may hear some
clicking sounds.
5. Try to pull the belt all the way out again. If it cannot be
pulled out, it is Switchable, ready to install your base. If it
can still be pulled out freely, it is ELR. Review the following
pages to properly install your infant base.
Note: Most vehicles manufactured after 1996 will have
Switchable retractors in the back seat. If you have any questions
about your retractor type, consult your vehicle owner's manual
or call Graco for assistance.
37