Lap Belt Installation - Graco SNUGRIDE 30 Manual Del Usuario

Lap Belt Installation

Always review your vehicle owner's manual for specific
information about your vehicle seat belts.
Grab the sides of the base at the
belt path and slide side to side and
front to back. The base should not
move more than 1" (2.5 cm).
Grab the sides of the base at the
belt path and slide side to side and
front to back. The base should not
move more than 1" (2.5 cm).
Locking Latch Plate
and No Retractor
When installing the base,
route the lap seat belt
through the proper path
and buckle it in. Then,
pull upwards on the tail
of the belt so that the lap
belt gets tight around the
base.
Sewn On Latch Plate
and ALR Retractor
Slowly pull the lap belt
all the way out. Route
the vehicle seat lap belt
through the proper belt
path and buckle it in.
Then, pull the lap belt
tight while feeding all
the slack back into the
retractor.
42