Graco SNUGRIDE 30 Manual Del Usuario página 38

How to Lock Your Lap/Shoulder Vehicle Seat Belt
Note: With the vehicle seat belt in
this locking mode, all the tension
is upwards in the shoulder belt.
This may start to tilt your base
sideways. If this happens, use a
locking clip instead of switching
the retractor. See Sliding Latch
Plate and ELR Retractor.
Sliding Latch Plate
and Switchable
Retractor
A latch plate that slides
freely on the belt webbing
and cannot, by itself, hold
the belt snug around a
base.
When installing the base,
route the vehicle seat
belt through the proper
belt path and buckle it in.
Slowly pull the shoulder
belt all the way out
to switch it to locking
mode. Then, as you pull
the vehicle seat belt tight,
feed all the slack back into
the retractor.
Grab the sides of the base
at the belt path and slide
side to side and front to
back. The base should
not move more than 1"
(2.5 cm).
38