Graco SNUGRIDE 30 Manual Del Usuario página 41

Sliding Latch Plate
and ELR Retractor
A latch plate that slides
freely on the belt webbing
and cannot, by itself, hold
the belt snug around a
base.
With this retractor, you will
need to use the locking clip
to lock the vehicle seat belt.
Route the vehicle seat belt
through the proper belt
path and buckle it in. Pull
the vehicle seat belt tight.
While pushing down on
seat, pinch the two straps
together behind the buckle
tongue. Unbuckle the belt
without allowing it to slip.
Attach locking clip to lap
and shoulder belts as
shown.
Buckle belt. Check that
lap belt does not move by
pulling hard. If belt loosens
or lengthens, repeat
procedure.
41
1" (2.5 cm)