Dyna-Glo DGL260SNP Manual Del Usuario página 17

TROUBLESHOOTING
PROBLEM
The burner will not
light with a match.
No gas flow or an
obstructed gas flow.
POSSIBLE CAUSE
1. Match not close enough to
burner ports.
2. Empty tank.
3. Poor connection between
the propane cylinder to the
regulator assembly.
4. Burner inlet blocked.
1. Empty tank.
2. Poor connection between
valve regulator and LP
cylinder coupling.
3. Burner inlet blocked.
CORRECTIVE ACTION
1. Position the match closer to burner ports.
2. Replace with a new propane cylinder.
3. Turn off griddle knob. Disconnect and re-
connect the propane cylinder to the regu-
lator assembly.
4. Clean the burner inlet (venturi)
and burner as described by the
Care and Maintenance section
in the manual.
1. Check fuel level and replace
fuel if necessary.
2. Turn off griddle knobs, close the LP
cylinder valve at top of cylinder
and check the connection
between the regulator valve
and cylinder coupling.
Disconnect and reconnect, if
necessary.
3. Clean the burner inlet (venturi)
and burner as described by the
Care and Maintenance section
in the manual.
17