Outside Mount - Levolor Cellular Shades Instalación

OUTSIDE MOUNT (OM)
Bracket
Bracket
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: Before marking bracket locations, ensure that your bracket placement
will not interfere with any components inside the headrail.
IMPORTANT: The rear of the brackets must be flush against a flat mounting surface.
Do NOT mount brackets on curved molding.
•
Center the headrail over the window opening at the desired height.
•
Use a pencil to lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark
the headrail end points over the window opening.
•
Mark approximately 1 - 2" in from each end of headrail for the installation
bracket locations.
— Allow a minimum of
top of the window molding.
•
With a pencil, mark the installation brackets or extension bracket screw locations
through the larger, oblong rear holes of the bracket, 2 screws per bracket.
•
Use a level to ensure all brackets are aligned.
•
If more than two installation brackets come with your order, space additional
bracket(s) evenly between the two end brackets, no more than 30" apart, and
mark drill hole locations.
⁄ in. between the bottom of the installation bracket and the
1
4
INSTALLATION
Continuous Cord Loop Lift Control
11