Outside Mount - Levolor Sheer Shadings Instalación

INSTALLATION
•
Drill the screw holes using a / " drill bit.
3
32
IMPORTANT: Use drywall anchors when mounting into drywall.
•
Use a level to check that the mounting surface is level.
Shim the brackets, if necessary.
•
Attach the installation brackets using the screws provided.
IMPORTANT: Do not overtighten the screws. Check to ensure
the lever can be moved easily side to side. If not, loosen the screws in one-eighth
turn increments until the lever can be moved easily.
IMPORTANT: The front edges of the installation
brackets must be level and aligned to each other.
•
If using spacer blocks:
— Stack spacer block(s) on top of the installation brackets,
— Using #6 Hex Head Screws, long enough for secure installation (not provided),
install screws up through the underside of the installation bracket and spacer
block(s) into mounting surface.
IMPORTANT: Do not add more than 1
Proceed to "Install the Shading" on page 11.

OUTSIDE MOUNT

Mount the Installation Brackets
•
Center the headrail over the window opening at the desired height. Use a pencil to
lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark the
headrail end points over the window opening.
•
Mark 2" to 3" from each end of the headrail.
— If more than two installation brackets came with your order, space additional
bracket(s) evenly between the two end brackets and mark their location. Mount
into wood whenever possible.
•
Center the installation brackets or extension brackets on your marks and mark
where to drill the screw holes.
— A minimum 1 ⁄ " flat vertical surface is required for the installation brackets.
1
8
Extension brackets require 1 1 ⁄
Single Headrail Shadings.
2" to 3" Space Evenly
Headrail End Mark
8
Continuous Cord Loop Operating System
20-0034-033_Sheer_Shadings_Cont_Cordloop_F_010621.indd 8-9
1 / in. of clearance using the spacer blocks.
2
".
4
Space Evenly 2" to 3"
Window Opening
Headrail End Mark
Lever
NOTE: Two additional installation brackets should be placed on each side of the panel split.
2" to 3"
Headrail End Mark
Spacer
Blocks 1 ⁄ "
1
— The tops of the installation brackets or extension brackets should be at the
2
Maximum
desired height. The brackets should be level and aligned.
IMPORTANT: The rear of the brackets must be flush against a flat mounting
surface. Do NOT mount brackets on curved molding.
1 / "
1
8
•
Drill the screw holes using a
IMPORTANT: Use drywall anchors when mounting into drywall.
•
Attach the installation or extension brackets using the screws provided.
IMPORTANT: The tops of the installation brackets or extension
brackets must be level with their front edges aligned.
Two-On-One Headrail Shadings.
Panel Split
Space Evenly 3" 3" Space Evenly
Window Opening
1 1 / "
4
3 / " drill bit.
32
Continuous Cord Loop Operating System
INSTALLATION
2" to 3"
Headrail End Mark
Extension
Bracket
9
1/6/21 4:47 PM