Andis CLC-3 Instrucciones De Uso Y Cuidado página 3

OPERATING INSTRUCTIONS
(Refer to Figure A unless noted).
Before starting your clipper, it must be pre-charged fully before using it for the
first time. To start clipper, push the power button; to stop, push the power
button again.
A
BLADE
LENGTH SETTING BUTTON
SHIFT KEY
ACCELERATION BUTTON
DECELERATION BUTTON
ON/OFF BUTTON
LCD SCREEN
AC/DC POWER ADAPTER
ADAPTER
CORD PLUG
4
UNIVERSAL AC/DC POWER ADAPTER
The unit is equipped with a universal AC/DC power adapter.
CHARGING CLIPPER
This battery charger is intended for use with Andis model CLC-3 clipper. Remove
the clipper and AC/DC adapter from the carton. Plug the adapter into a 120V
AC outlet, or according to your local power standards. Confirm the voltage
available at each overseas location before using the appliance. For connection to
B
a 240V supply, use an attachment plug adapter of the proper configuration for
the power supply receptacle.
The clipper must be OFF for the battery to charge. Plug the adapter cord plug
directly into the bottom of the clipper. The clipper has a lithium-ion battery that
cannot be damaged by overcharging. We recommend that the clipper be
unplugged if not in use for seven or more days.
CLIPPER INDICATOR LIGHTS:
Speed Indicator
C
This clipper has five speed settings
that it can run at:
Speed 1: 5,000 RPM (displays as 50)
Speed 2: 5,500 RPM (displays as 55)
Speed 3: 6,000 RPM (displays as 60)
Speed 4: 6,500 RPM (displays as 65)
Speed 5: 7,000 RPM (displays as 70)
D
Usable Time
Remaining battery life shown in minutes until the battery will be depleted and
will need a recharge.
Charge Icon
This red icon will illuminate and flash when the battery is on its last 10 minutes of
use. Once the battery is nearing depletion, the user will hear 3 clicking sounds as
a final reminder to charge before battery dies.
The icon will blink on and off while the unit is charging. The battery only charges
when the unit is OFF.
E
OIL
Low Oil Warning
After a usage of 60 minutes, the red low oil warning light will start blinking to
indicate that the product needs to be cleaned. At this time, the blade should be
disinfected and oiled. Please see the "Care and Servicing of your Andis Clipper
Blades" section for additional instructions.
SPEED INDICATOR
USEABLE TIME
CHARGE ICON
LOW OIL WARNING
5