Fuse Replacement - Best U102 Serie Manual De Instrucciones

HALOGEN BULBS
This range hood requires two halogen bulbs (Type
T3, 12Volt, 20Watt Max, G-4 Base).
WARNING: Always switch off the elec-
tricity supply before carrying out any opera-
tions on the appliance.
To change bulbs:
1. Open the cover by prying from the proper slots.
- DO NOT ROTATE.
!
CAUTION: Bulb may be hot.
2. Replace with a Type T3, 12Volt, 20Watt Max,
G-4 Base bulb. Do not touch replacement bulb
with bare hands!
DO NOT use bulbs greater than 20 Watts.
Bulbs greater than 20 Watts will cause the
fuse to open.

FUSE REPLACEMENT

IF LIGHTS FAIL TO OPERATE, DISCONNECT
POWER AT THE SERVICE ENTRANCE.
CHECK THE FUSE AND REPLACE IF NEC-
ESSARY.
1.Remove the grease fi lter and pull the visor open.
2.Locate the fuse holder on the top right hand side
of the light housing.
3.Unscrew the fuse holder cap and remove the
fuse.
4.Replace the fuse with the same size and amper-
age (5 x 20mm, 4 amp, 125 volt).
DO NOT use fuses greater than 4 Amps.
Fuses greater than 4 Amps may damage
the transformer.
5.Reinstall the fuse cap and grease fi lter.
6.Reconnect power at the service entrance.
- 5 -