General Description; Extent Of The Delivery - Grizzly ERT 230 Traducción Del Manual De Instrucciones Original

GB
in these Instructions must only be
carried out by an authorised servicing
agency.
• Treat the equipment with the great-
est care. Always keep the equipment
clean for better and safer work. Follow
the maintenance instructions.
• Never overload the equipment. Al-
ways work within the stated capacity
range. Do not use low-power ma-
chines for heavy-duty work. Do not
operate the equipment for purposes
for which it is not intended.
• Always inspect the equipment before
it is to be used. Do not operate the
equipment if safety devices, parts of
the cutting device or bolts are missing,
worn out or damaged.
Electrical safety:
Always keep the extension cable
well away from the cutting tools.
Should the power cable become
damaged during work, then in-
stantly disconnect the power cable
from the mains. DO NOT TOUCH
THE POWER CABLE BEFORE
IT HAS BEEN DISCONNECTED
FROM THE MAINS!
• Before each usage, check the mains
power cable and the extension cable
for damage and signs of aging. Do not
use the device if the cable is damaged
or worn.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
fied person in order to prevent haz-
ards.
• Check that the mains voltage is the
same as indicated on the rating plate.
• Connect the equipment to a power
18
socked with a residual-current circuit
breaker that has a rated current of not
more than 30 mA.
• Protect the equipment from moisture.
The equipment must not be moist nor
operated in a moist environment.
• Always check the equipment, power
cable and plug for damage before
operating the equipment. Avoid body
contact with earthed parts (e.g. metal
fences, metal posts).
• Only use extension cables with a
maximum length of 75 m that have
been approved for open-air use. The
stranded cord diameter of the exten-
sion cable must be at least 2.5 mm
Always unreel a cable drum to its full
length so that the entire cable can be
inspected for damage.
• Never pass an operating equipment
over the extension cable. Ensure that
the power cable is always trailing be-
hind the operator.
• Use the envisaged cable suspensions
when attaching an extension cable.
• Never carry the equipment by its
power cable. Never pull the cable to
disconnect the plug from the mains
socket. Protect the cable from heat, oil
and sharp edges.

General description

The illustration can be found on
page 2.

Extent of the delivery

Carefully unpack the trimmer and check
that it is complete:
- Lawn trimmer (2 parts)
- protection cover with 2 integrated
screws
- Instruction Manual
.
2