Kohler K-1914 Instrucciones De Instalación página 5

Level Sensors
Toe Tap Drain
Door Switch
Handle
Label
Operating Your Bath
Using the Bath
NOTE: A removable label is included with the literature packet. It should be applied over the door switch
as a reminder on how to operate the bath.
With the door lowered, turn on the water and adjust it to the desired temperature. The water will
run into the footwell and exit through the sidewall drain and toe tap drain (if open) until the door
is closed.
Enter the bath and close the toe tap drain located in the footwell.
Lightly grasp the handle recess and raise it until the latches on each side of the door engage. The
drain valve will close and the seal will begin inflating.
IMPORTANT! If water does not cover the level sensors within 2 minutes, the drain valve will open
automatically.
Immediately add water to the bath until it is above the level sensors.
Fill the bath until the water is midway up the sidewall. More water can be added if you choose to
bathe without turning on the blower.
Airjet Operation
Press the On/Off button on the user keypad to turn on the blower motor.
After approximately 20 minutes of continuous operation, the blower motor will stop. If desired,
press the On/Off button to restart the blower motor.
If desired, press the up or down arrow buttons to change the air flow rate.
When finished bathing, press the On/Off button a second time to turn off the blower motor.
Kohler Co.
1 - To Drain
Press button once
and
press floor drain
2 - To Exit
When drained,
lift latch on outside
of rising wall
Purge Mode
User Keypad
Sidewall Drain
Airjets
Footwell
5
Increases Flow
Decreases
On/Off Flow
1128535-5-G