Starting Operation - Würth EB 12-A Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-1120-002.book Page 14 Wednesday, June 8, 2016 2:39 PM
EC-Declaration of Conformity
We declare under our sole responsibility that the product
described under "Tool Specifications" complies with all
applicable provisions of the directives 2011/65/EU,
2014/30/EU, 2006/42/EC including their amendments
and is in conformity with the following standards:
EN 60745-1, EN 60745-2-8, EN 50581.
Technical file (2006/42/EC) at:
Adolf Würth GmbH & Co. KG, Abt. PCM
Reinhold-Würth-Straße 12–17
74653 Künzelsau
GERMANY
www.wuerth.de
Frank Wolpert Dr.-Ing. Siegfried Beichter
General Manager General Manager
Künzelsau: 01.08.2016
Battery Charging
 Use only the chargers listed in the tool specifi-
cations. Only these chargers are matched to the lithium-
ion battery of your power tool.
Note: The battery supplied is partially charged. To ensure
full capacity of the battery, completely charge the battery in
the battery charger before using your power tool for the first
time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
Battery Charge-control Indication
The three green LEDs of the battery charge-control indicator 4
indicate the charge condition of the battery 2. For safety rea-
sons, it is only possible to check the status of the charge con-
dition when the machine is at a standstill.
To indicate the charge condition, press and hold button 3 of
the switched off machine.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Removing the battery
To remove the battery 2, press the unlocking buttons 1 and
pull the battery out of the machine to the rear. Do not exert
any force.
Inserting the battery
 Use only original Würth lithium-ion batteries
with the voltage listed on the nameplate of
your power tool. Using other batteries can lead to
injuries and pose a fire hazard.
Note: Use of batteries not suitable for the machine can lead
to malfunctions of or cause damage to the power tool.
Insert the charged battery 2 into the handle until it can be felt
to engage and faces flush against the handle.
Switching On and Off
To start the machine, push the On/Off switch 5 forward so
that the "I" is indicated on the switch.
To switch off the machine, push the On/Off switch 5
toward the rear so that the "0" is indicated on the switch.
To save energy, only switch the power tool on when using it.
The lithium-ion battery is protected against deep discharging
by the "Electronic Cell Protection (ECP)". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
Note: If the machine should automatically switch off because
of a discharged or overheated battery, make sure to set the
machine's On/Off switch 5 to off. Charge the battery and
allow it to cool down before restarting the machine. Other-
wise the battery can become damaged.
Capacity
2/3
1/3
<1/3
Reserve

Starting Operation

14