Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION ON MOUNTING AND USE
GB
Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set out
in this manual. All responsibility,
inconveniences, damages or fires caused by not complying
with the instructions in this manual, is declined.
Installation
The cooker hood must be placed at a minimum distance of 65
cm from the cooking plane for electric cookers and 75cm for
gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this has to be taken into account.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only. Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be easily removed, in
case maintenance is ever required.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version
F: the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.
Electrical connection
The electrical tension must correspond to the tension noted on the
label placed inside the cooker hood. Connect the electrical plug,
where provided, to the an easily accessible outlet in conformity with
local standards in force.
Where an electrical plug is not provided (for direct connection
to electrical network) place a standards approved bipolar
switch with an aperture distance of not less than 3mm
(accessible) from he contacts.
Operation
C
B
A
From off position the stand-by control mode can be acti-
vated by pressing any button. The symbol will then light up
softly giving the user the possibility to see and choose the
function.
By pressing one more time any button will activate the
corrisponding function and the symbol will then light up
completely. To ensure a low level of energy consumption,
this control has a special device which lets the symbols
remain lighted up half way, in a stand mode, for about 1
minute. The symbols will switch off afterwards.
A. ON/OFF button- atmosphere light: by pressing this
button 4 lights situated at the back of the hood and on the
sides will switch on giving a decorative effect with a soft
light.;
B. ON/OFF button- hood's light : by pressing this but-
ton 2 lights will switch on lighting the hob;
C. ON/OFF button- 4 speed motor: by pressing this
button the hood will start to operate at the same speed as
before being switched off. By using D and E it is possible
to change the extracting speed (capacity);
for any eventual
D
E
F
D.Decreasing extracting speed (capacity) button: by
pressing this button the extracting speed (capacity) will de-
crease;
E.Increasing extracting speed (capacity) button: by
pressing this button the extracting speed (capacity) will in-
crease;
F. ON/OF TIMER: by pressing this button the selected ex-
tracting speed (capacity) will last for 5 minutes;
Selected extracting speed (capacity) indicator and
filter saturation;
Grease filters saturation : after every 40 hours of use of the
hood , the speed indicator will flash slowly indicating that the
metal filters need to be washed.
Charcoal filters saturation : after every 120 hours of use
of the hood , the speed indicator will flash fast indicating that
the charcoal filters need to be replaced.
Note: by pressing at the same time the buttons D and E will
reset the filters saturation indicator. Attention! This func-
tion should only be used after performing the mainte-
nance of the filters.
Maintenance
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
C l e a n i n g
The cooker hood should be cleaned regularly internally and
externally.
For cleaning use a cloth moistened with denatured alcohol or
neutral liquid detergents. Avoid abrasive detergents.
6
Publicidad
