Mounting The Fixed Support; Remove Side Shelf And Barrel Chimney Hole Cap; Mount The Smoker To The Grill Barrel - Pit Boss PB0600SS Manual Del Usuario

4. MOUNTING THE FIXED SUPPORT

Parts Required:
1 x Fixed Support (#4)
4 x Screw (#E)
Installation:
• Mount the Fixed Support onto the exterior side of the
Main Cabinet using four screws.
NOTE: Pay attention to the direction of the hole when
installing, the round hole is on the bottom. Do not
install in reverse.
5. REMOVE SIDE SHELF AND BARREL CHIMNEY
HOLE CAP
Parts Required:
1 x Pit Boss® Grill (not included)
Installation:
• Remove the screws that secure the Side Shelf and
remove the Side Shelf.
• Remove the screws that secure the Barrel Chimney
Hole Cap and remove the Barrel Chimney Hole Cap.

6. MOUNT THE SMOKER TO THE GRILL BARREL

Parts Required:
1 x Pit Boss® Grill (not included)
4 x Screw (#A)
2 x Washer (#B)
Locking washer (#C)
2 x
Installation:
• Install two screws on the side of the Main Barrel and
tighten only half way. Hook up the Main Cabinet on
the screws first, then secure the screws in place. Note
illustration 6A.
• From outside, secure the Main Cabinet to the side
panel of the Main Barrel using two screws, washers
and locking washers. Note illustration 6B.
6
4
4
E
5
6
A
6A
BCA
6B