Mounting The Body Bracket Handles; Securing The Chimney; Mounting The Lid Handle - Pit Boss Champion PBV24CB Guía De Montaje

2. MOUNTING THE BODY BRACKET HANDLES

Parts Required:
2 x Body Bracket Handle (#5)
4 x Screw (#D)
4 x Locking Washer (#F)
4 x Washer (#G)
Installation:
• Insert the open end of a Body Bracket Handle into the top end of the
Body Bracket, pushing it in until the mounting holes align. Secure using
two washers, locking washers, and screws. Repeat installation for the
second Body Bracket Handle. See illustration for proper arrangement.

3. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Assembly (#1)
4 x Screw (#E)
Installation:
• First, twist the Chimney Cap off of the Chimney Stack. This will make
the Chimney Stack easier to install. Locate the round opening on the
top of the Barrel Lid. From the outside, secure the Chimney Stack to the
top of the Barrel Lid using four screws. The screw will fasten to the self-
clinching nut on the inside of the Barrel Lid. Note illustration 3A.
• Replace the Chimney Cap by twisting it back onto the top of the Chimney
Stack. Note illustration 3B.
NOTE: Adjust the Chimney Cap to affect the airflow inside the
Smoker. If cooking at low temperature, keep the cap more closed to
restrict airflow. If cooking at a high temperature, keep the cap more
open to increase airflow.

4. MOUNTING THE LID HANDLE

Parts Required:
1 x Lid Handle (#3)
Installation:
• Remove the pre-installed screws, locking washers, and washers from the
Lid Handle. From the inside the Lid of the Barrel Body, insert one screw,
locking washer, and washer to protrude to the outside, then secure the
screw (from the inside) into the Lid Handle. Repeat same installation for
other end of the Lid Handle.
2
5
GFD
GFD
5
3A
E
E
E E
3B
4
3
A
5