Securing The Chimney; Mounting The Grease Exhaust Tube; Mounting The Fixed Support; Remove Side Shelf And Barrel Chimney Hole Cap - Pit Boss PB0600SS Manual Del Propietário

2. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Cap (#1)
1 x Chimney Stack (#2)
4 x Screw (#E)
Installation:
• Locate the chimney opening on the top of the Main
Cabinet. From the outside, secure the Chimney to the
top panel using four screws. The screw will fasten to
the self-clinching nut on the inside of the cabinet.
Next, twist the Chimney Cap onto the top.
NOTE: Adjust the damper handle to affect the airflow
in the main chimney.

3. MOUNTING THE GREASE EXHAUST TUBE

Parts Required:
1 x Grease Exhaust Tube (#7)
3 x Screw (#E)
Installation:
• Mount the Grease Exhaust Tube onto the bottom of
the Main Cabinet using three screws, from the outside.

4. MOUNTING THE FIXED SUPPORT

Parts Required:
1 x Fixed Support A (#4)
1 x Fixed Support B (#10)
4 x Screw (#E)
Installation:
FOR MOST GRILLS
• Mount Fixed Support A onto the exterior side of the
Main Cabinet using four screws. Note illustration 4A.
NOTE: Pay attention to the direction of the holes
when installing as the round hole is on the bottom. Do
not install in reverse.
FOR PB850PS2 / PB1150PS2 / PB1600PS1 GRILLS
• Mount Fixed Support B onto the exterior side of the
Main Cabinet using four screws. Note illustration 4B.
6
2
1
E
2
3
7
E
4A
4
E
4B
4
5. REMOVE SIDE SHELF AND
BARREL CHIMNEY HOLE CAP
Parts Required:
1 x Pit Boss® Grill (not included)
Installation:
FOR MOST GRILLS
• Remove the screws that secure the Side Shelf and
remove the Side Shelf. Remove the screws that secure
the Barrel Chimney Hole Cap and remove the Barrel
Chimney Hole Cap. Note illustration 5A.
FOR PB850PS2 / PB1150PS2 / PB1600PS1 GRILLS
• Remove the screws that secure the Side Shelf and
remove the Side Shelf. Remove the screws that secure
the Barrel Chimney and remove the Barrel Chimney.
Note illustration 5B.
6. MOUNT THE SIDE SMOKER
TO THE GRILL BARREL
Parts Required:
1 x Pit Boss® Grill (not included)
1 x Fixed Support C (#11)
4 x Screw (#A)
2 x Washer (#B)
2 x Locking washer (#C)
2 x Screw (#F)
Installation:
FOR MOST GRILLS
• Install two screws (A) on the side of the Main Barrel
and tighten only half way. Hook up the Main Cabinet
on the screws first, then secure the screws in place.
Note illustration 6A-1.
• From outside, secure the Main Cabinet to the side
panel of the Main Barrel using two screws (A), washers
and locking washers. Note illustration 6A-2.
5A
5B
6A
A
6A-1
B C A
6A-2
7