Troubleshooting; Fault Correction - Grizzly BRM 4013 Traducción Del Manual De Instrucciones Original

Troubleshooting

Problem
Engine does not
start
Engine starts but
equipment does
not run at full
power
Engine splutters,
stops
Engine over-
heats
Engine smokes
Output unsatis-
factory or engine
labouring
Blade does not
turn
Abnormal nois-
es, rattling or
vibrations
Possible Cause
Too little petrol in the tank
Incorrect starting sequence
Spark plug connector (
not put on correctly
Sooted spark plug
Incorrectly adjusted carburet-
tor mix
Dirty air filter (
10)
Incorrectly adjusted carburet-
tor mix
Incorrectly adjusted carburet-
tor mix
Sooted spark plug (
Ventilation holes blocked
Incorrect spark plug (
Too little engine oil in the
engine
Dirty air filter (
10)
Too little engine oil in the
engine
Grass too short or too long
Blade blunt
Blade blocked with grass,
grass collection box full, ejec-
tion channel blocked
Blade blocked with grass
Blade not installed correctly
Blade not installed correctly
Blade damaged

Fault Correction

Fill with petrol
Follow the instructions for starting the
engine (see "operation")
Attach the spark plug connector
14)
Clean, adjust or replace the spark
plug (see "cleaning and mainte-
nance")
Have the carburettor adjusted by a
specialist workshop
Replace the air filter (see "cleaning
and maintenance")
Have the carburettor adjusted by a
specialist workshop
Have the carburettor adjusted by a
specialist workshop
Clean, adjust or replace the spark
plugs (see "cleaning and mainte-
15)
nance")
Clean the ventilation slot
15)) Change the spark plug
Fill with engine oil (see "initial opera-
tion")
Replace the air filter (see "Cleaning
and Maintenance")
Fill with engine oil (see "initial opera-
tion")
Change the cutting height (see "set-
ting the cutting height")
Have the blade sharpened or replaced
by a specialist workshop
Remove the grass (see "cleaning and
maintenance")
Remove the grass
Have the blade installed by a special-
ist workshop
Have the blade installed by a special-
ist workshop
GB
89