Hilti PM 30-MG Manual De Instrucciones Original página 22

5.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
▶ Pull the battery out of its holder in the device.
5.4 Matching two points over distance by fine adjustment
1. Position the device with the lower plumbing beam centered on the reference cross on the ground.
2. Turn the knob for fine adjustment until the vertical laser beam is aligned with the second, remote control
point.
5.5 Switching the laser beams on
1. Set the selector switch to the
➥ The vertical laser lines are switched on.
2. Press the line mode button repeatedly until the desired line mode is set.
➥ The operating modes change in the following sequence and the sequence repeats itself: vertical lines,
vertical side line, horizontal line, vertical and horizontal lines.
5.6 Switching the laser beams off
1. Set the selector switch to the OFF position.
➥ The laser beam is switched off and the pendulum is locked.
CAUTION
Risk of injury by unintended starting!
▶ Before inserting the battery, make sure that the product is switched off.
2. The laser beam is switched off automatically when the battery is low.
5.7 Setting the laser beam for the "Inclined line" function
1. Set the selector switch to the
2. Press the line mode button repeatedly until the desired line mode is set. → page 16
When the "Inclined line" function is active, the pendulum is locked and the laser is not leveled.
The laser beam(s) blink every 5 seconds.
5.8 Examples of applications
5.8.1 Transferring heights
5.8.2 Setting up drywall track for a partition wall 3,
5.8.3 Vertical alignment of pipes
5.8.4 Aligning heating units
5.8.5 Aligning door and window frames
16 English
Printed: 08.05.2019 | Doc-Nr: PUB / 5492771 / 000 / 00
position (ON / unlocked).
position (ON / locked).
2
5
6
7
4
2243556
*2243556*