Environmental Protection; Declaration Of Conformity - Worx WX530 Manual De Instrucciones

water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean. Keep all working controls free of dust.
Periodically clear dust and chips from guard and base to ensure proper performance.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery use and storage is 0
The recommended ambient temperature range for the charging system during charging is 0

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of with household waste. Please recycle where facilities
exist. Check with your
TROUBLE SHOOTING
Symptom
Tool will not start when
operating the on/off
switch.
Cutting depth is less
than that is set.
Blade spins or slips
14 14
Blade will not cut a
straight line.
Blade kicks back when
beginning a cut
DECLARATION OF
CONFORMITY
We,
POSITEC Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product,
Description Battery-powered circular saw
Type Designation WX530 WX530.1 WX530.9
(5-designation of machinery, representative of
saw)
Function Cutting various materials with a
rotating toothed blade
Complies with the following directives,
2006/42/EC
2014/30/EU
2011/65/EU&(EU)2015/863
Standards conform to
EN 62841-1
Cordless Circular Saw
local authorities or retailer for recycling advice.
Possible Causes
Battery pack not securely fitted
into tool.
Battery pack is not charged.
Sawdust accumulated at the rear
of the base.
Blade is not tightly engaged with
the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Blade is not spinning fast enough
C-45 C.
O O
Possible Solution
Make sure battery is fully charged and
securely fit into the tool.
Charge the battery pack.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Remove the blade, and reassemble it as
described in Saw blade assembly and
removing section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Allow the saw blade to reach full speed
prior to beginning a cut in the material.
EN 62841-2-5
EN 55014-1
EN 55014-2
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH Grüner Weg
10, 50825 Cologne, Germany
2019/5/28
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P . R. China
C-40 C.
O O
EN