Environmental Protection - Worx WX523 Manual Original

Saw blade Assembly and
Removing
WARNING: Always
remove the battery
before changing the blade!
Safety On/Off Switch
WARNING:To avoid
cutting injury from the
sharp blade, please don't put
your hands around the Base
Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Cross and Rip Cutting
NOTE: To avoid injury from
Kickback, please don't start
cutting until the blade runs
stably.
Cutting Depth Adjusting
Using the laser light feature
Replacing laser batteries
Parallel Guide
Pocket Cutting
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition and
the tooth count of the saw blade. Therefore, use only
sharp saw blades that are suited for the material being
cut.
Choice of blades: 24 teeth for general work, approx. 40
teeth for finer cuts, more than 40 teeth for very fine cuts
into delicate surfaces, diamond for tile, cement board,
etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH CARE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
Lithium-Ion Cordless Circular Saw
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional lubrication
See Fig. B
or maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
See Fig. C1, C2
persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base to
ensure proper performance.
ENVIRONMENTAL
PROTECTION
See Fig. D1, D2
See Fig. E1, E2
retailer for recycling advice.
See Fig. F
See Fig. G1-G3
See Fig. H1, H2
See Fig. I1, I2
See Fig. J
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
17
EN