Environmental Protection; Declaration Of Conformity - Worx WX520. Serie Manual Original

lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
Periodically clear dust and chips from guard and base to
ensure proper performance.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
TROUBLE SHOOTING
Symptom
Tool will not start when
operating the on/off switch.
Cutting depth is less than that
is set.
Blade spins or slips
14 14
Blade will not cut a straight line.
Blade kicks back when
beginning a cut
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Battery-powered circular saw
Type Designation WX520 WX520.X (5 - designation
of machinery, representative of circular saw)
Function Cutting various materials with a rotating
toothed blade
Complies with the following Directives:
2006/42/EC, 2014/30/EU, 2011/65/EU&(EU)2015/863
Standards conform to
EN 62841-1, EN 62841-2-5, EN 55014-1, EN 55014-2
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
20V Cordless Brushless Circular saw
of tool and battery is 0°C-45°C.
The recommended ambient temperature range for the
charging system during charging is 0°C-40°C.
ENVIRONMENTAL
PROTECTION
or retailer for recycling advice.
Possible Causes
Battery pack not plugged in.
Battery pack is powered off.
Sawdust accumulated at the rear
of the base.
Blade is not tightly engaged with
the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Blade is not spinning fast enough
Grüner Weg 10, 50825 Cologne, Germany
2020/07/23
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
Possible Solution
Check to make sure battery pack is
connected well into a working outlet.
Charging the battery.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Remove the blade, and reassemble it as
described in Saw Blade Assembly and
Removing section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Allow the saw blade to reach full speed
prior to beginning a cut in the material.
EN