Working Hints For Your Jigsaw; Maintenance; Troubleshooting; Environmental Protection - Worx WX542 Manual Original

Straight Cut and Curve Cut
Bevel Cut
NOTE: Remove the vacuum
adapter before adjust the base
plate.
NOTE: Rotate the base plate to
the desired position according
to the scale. Ensure the blade
is engaged between the blade
positioning wheel .
Plunge Cut
5. WORKING HINTS FOR
YOUR JIGSAW
If your power tool becomes too hot, please run your
jigsaw no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
Always use a blade suited to the material and material
thickness to be cut. For tight curves it is best to use
a narrow saw blade. When sawing metal or similar
materials, apply coolant/lubricant alongside the
cutting line.
Always ensure the workpiece is firmly held or clamped
to prevent movement. Any movement of the material
may affect the quality of the cut. The blade cuts on the
12 12
upward stroke and may chip the uppermost. Ensure
your uppermost surface is a non-visible surface when
your work is finished.
For easier control, use low speed to start cutting and
then increase to correct speed.
In order to avoid operation malfunctions, do not saw
gypsum board from below or overhead.
The guide roller should occasionally be checked for
wear and lubricated with a drop of oil. If it is worn, it
must be replaced.

6. MAINTENANCE

Remove the battery pack from the tool before carrying
out any adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C.
The recommended ambient temperature range for the
charging system during charging is 0°C-40°C.
20V Cordless Brushless Jigsaw

7. TROUBLESHOOTING

See Fig. E1, E2
Symptom
See Fig. F1-
F3, G
The tool
suddenly
stops
during
See Fig. H1, H2
operation.
8. ENVIRONMENTAL
PROTECTION
9. DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
On behalf of Positec declare that the product
Description Worx Cordless Jigsaw
Type Designation WX542 WX542.X (540-559 -
designation of machinery, representative of Jig
Saw)
Function Sawing various materials
Complies with the following directives,
2006/42/EC,
2014/30/EU,
2011/65/EU&(EU)2015/863
Standards conform to
EN 62841-1,
EN 62841-2-11,
EN 55014-1,
EN 55014-2
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
Possible
Possible Solution
Causes
Overload Relieve the load
Battery on the machine
temperature immediately and
too high allow cooling for
approx. 30 seconds
by running the
machine on no-load.
Low battery Charge the battery
capacity pack.
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling advice.
EN