Conversion - ARTROMOT SP3 Instrucciones Para El Uso

11. Place the ARTROMOT
bottom of the shipping box. Then
pack the two extra boxes for the
programming unit and the footplate
+ bracket in the shipping box along
with the padding material, as shown
below.
Extra box with
programming unit

6.4 Conversion

®
The ARTROMOT -SP3 can be used
on the left and on the right ankle joint.
However, the device must be converted
first. This is done very quickly.
1. Activate the "transport setting"
function in the menu (see also
5.3) and start the ARTROMOT
2. Remove the footplate (7) as well as
its bracket (11). To do so, pull it from
the square-end guide at motor B.
(Fig. G)
3. Loosen thumbscrew (12) used to
mount motor B to the moving brak-
ket (15). Then pull the motor upward
and remove (Fig. H).
4. Mount motor B on the opposite side
of the carriage, using the thumb-
screw.
® -SP3 at the
Extra box with
footplate/bracket
and power cord
® -SP3.
67
5. Push the footplate bracket into the
square-end aperture on motor B.
Observe the marks: red dot on
square rod of the footplate bracket
to match red dot on square-end
aperture on motor B, mark L or R on
the footplate bracket to match mark
L or R on the motor housing
Note!
- To assist in the conversion, motor B
is equipped with a side identifica-
tion function.
The following symbols may appear
on the display during conversion:
(example) conversion from left to
right:
motor on the left-hand side:
motor removed from bracket:
conversion to the right-hand side
completed:
- If, after the conversion, the foot-
plate bracket and thus the footplate
is at an inadmissible angle, the dis-
play shows:
Please press the START key and
the carriage will automatically move
to the permitted range and stop.