Descargar Imprimir esta página

KERN PCB-A01 Manual De Instalación página 6

Publicidad

Beispiel mit Zwischenboden und Bohrungen
Example with spacer and holes
Exemple avec le palier intermédiaire et le percage
Ejemplo con fondo doble et aberturas
Esempio con doppio fondo e trapanazione
ECB/ECE
C
1. Mit einem Schraubenzieher den Zwischenboden
seitlich verschieben.
Use a srew driver to push the spacer to left or
right side completely.
Avec un tournevis, pousser le palier sur le côté.
Utilice un destornillador para empujar el fondo
doble completamente hacia la izquierda o
derecha
Sposate il doppio fondo con il cacciavite a
destro.
2. Den Zwischenboden mit dem Schraubenzieher
nach unten drücken, bis das andere Ende
hervorsteht.
Push the spacer downward by the screw driver
until the other end title up the surface of the
bottom cabinet.
Appuyer vers le bas sur le palier avec le
tournevis jusqu'á ce que l'autre extrémité sorte
vers le haut.
Empuje el fondo doble en una esquina hacia
abajo con el destornillador
Premere giu il doppio fondo con il cacciavite
finché si muove sopra la destra parte
3. Den Zwischenboden herausnehmen.
Remove the spacer out from the bottom cabinet
by another hand.
Enlever le palier en plastique.
Remueva el fondo doble del compartimiento
Togliere il doppio fondo
4. Den Akku in das Batteriefach einlegen
Put the rechargeable battery pack into the
battery compartment
Mettre l'accu dans le logement batterie.
Coloque el acumulador en el compartimiento de
batería
Inserire e collegare l'accumulatore.

Publicidad

loading

Este manual también es adecuado para:

Pcb-a06