Thermador PRD304GHC Instalación página 2

THESE INSTRUCTIONS ARE NOT MEANT TO BE A
SUBSTITUTE FOR THE INSTALLATION MANUAL.
REFER TO THE NOTED PAGE NUMBERS BELOW FOR
THE CORRESPONDING PAGES IN THE INSTALLATION
MANUAL WHERE THESE CHANGES APPLY. BE SURE
TO READ AND FOLLOW THE INSTRUCTIONS IN THE
INSTALLATION MANUAL FOR COMPLETE
INSTALLATION INSTRUCTIONS AND IMPORTANT
SAFETY INFORMATION.
Tools Needed (see page 3)
Tools Needed
7/16" box end wrench or
ratchet
3/16" (4.76 mm) drill bit
Hand or electric drill
T-20 Torx screwdriver
Level
Phillips & flathead
screwdrivers
Items Not Included
Drywall / Concrete Anchors
Rope/Twine
Strain Relief
2 – NPT Flare Adapters
Lowback Height Change for 30" Models
(see page 6
)
1/8" (3.17 mm) drill bit
12" Adjustable wrench
Tape measure
Marking instrument
Furniture dolly
Protective gloves
Pipe Compound / Tape
¾" (19 mm) Flex Line
Cord Kit or Conduit
Moving the Range (see page 10)
Range Weight
Shipping Weight
Weight without
packing materials
Removing the Pallet Bolts
1. To remove the (4) pallet bolts in the front and in the
back, use a 7/16" wrench or ratchet and socket to
remove the pallet bolt from the bottom of the pallet.
Discard the wood packing block inserts.
2. Lift range and remove it from the pallet. Use additional
help as required to remove from pallet.
3. Transport the range by dolly close to its final location.
Unit should not be dollied from the front.
4. The range can then be tipped back and supported on
the rear legs while the dolly is carefully removed. THE
FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
• Step 4 through Step 8 must be completed before
the range is placed in its final position. For proper
performance, the range must be level.
30" 36"
Range Range Range
377 lbs 395 lbs 560 lbs
(171 kg) (179 kg) (254 kg)
293 lbs 337 lbs 470 lbs
(133 kg) (153 kg) (213 kg)
English 1
48"