Before Operation; Installing The Battery Pack; Adjusting The Handle Height - Toro Flex Force Power System Recycler 20361 Manual Del Operador

Operation
Note:
Determine the left and right sides of the machine from the normal operating position.

Before Operation

Installing the Battery Pack

Important:
Use the battery pack only in temperatures that are within the appropriate range; refer
to Specifications (page
1. Make sure that the vents on the battery are clear of any dust and debris.
2. Lift up the battery-compartment lid (A of
3. Line up the cavity in the battery pack with the tongue on the machine and slide the battery pack into the
compartment until it locks into place (B of
4. Close the battery-compartment lid (C of
Note:
If the battery-compartment lid does not close completely, the battery is not fully installed.

Adjusting the Handle Height

You may raise or lower the handle to a position comfortable for you.
Rotate the handle lock, move the handle to 1 of 2 positions, and lock the handle into position
11).
Figure
Figure
9).
Figure 9).
9).
Figure 9
Figure 10
12
g274513
(Figure 10).
g274514