Zoeller Z Control Apak 10-4013-A Instrucciones De Instalación página 4

By connecting the APak to the Z Control
®
notifications. In addition, the user can verify the APak
are sent. Other visual information such as input status and battery level are available through the web and app interfaces.
Before you begin:
• Know what your Wi-Fi
®
including capitalization. This will prevent the most common troubleshooting issue.
• Verify your Wi-Fi router is connected to the internet.
®
• Verify your phone, tablet, or computer has working Wi-Fi
installation process.
• Create a free account at zcontrolcloud.com.
• Locate the APak 's Device ID on the top sticker.
®
Connection Steps:
1. Apply AC Power to the APak
AP Mode* and is transmitting an SSID (see Figure H). If the LED is blinking and not in AP mode, either press the Silence button for 12 seconds and let
go OR hold the Silence button while applying AC power. The LED will now be off, indicating the APak
This LED should be off when
APak is in AP mode.
®
When user is connected to
APak to set up Wi-Fi , LED
® ®
will blink.
When APak is connected to
®
router and Z Control Cloud,
®
this LED will be solid.
AC power must be used
for AP mode to work
CONNECTING THE APAK
Cloud using the built-in Wi-Fi
®
's readiness, remotely silence alarms and reset the unit, configure settings, and modify how notifications
®
router is named (i.e. its SSID) and its password. Double check you know the correct password and exactly how it is spelled,
(see note below for battery only installation**). The Z Control
®
Figure H
© Copyright 2018 Zoeller
TO Z CONTROL
®
, the user can set up free alert messages via email, text, and mobile app "push"
®
, can connect to your Wi-Fi router, and that you can be close to the APak
® ®
Co. All rights reserved.
®
4
®
LED will blink and then turn off, indicating the APak
®
is in AP Mode.
®
*AP Mode is when the APak is broadcasting its
®
"name", or SSID. The SSID is in the format ZCTL_
APAK_xxxx where "xxxx" is the first 4 digits of your
APak 's Device ID. The APak 's SSID will show up in
® ®
your phone/tablet/computer's list of available Wi-Fi
and selecting it will give you direct connectivity to the
APak . This is required in order to give the your APak
®
the password credentials needed to connect to the
Wi-Fi of your choice.
®
**Battery Only Mode. The APak
®
an SSID when powered by batteries (DC) only. It
must have AC power to broadcast an SSID. Once
the APak is connected to Wi-Fi
® ®
removed if desired. Since the APak
seen AC power and it has been removed, the APak
will now beep every 30 seconds indicating a power
outage. To remedy, remove battery power for a
moment, then reinsert batteries. The APak
longer alarm for AC Power Out (unless AC Power
is again applied and then removed). The LEDs and
alarm will behave differently than when AC is present
in order to conserve battery power. In battery only
mode, the APak will check into the Z Control
®
far less often in order for the batteries to last for
approximately 1 year.
during the
®
is in
®
,
®
®
will not broadcast
, AC power may be
has previously
®
®
will no
®
Cloud
®