Zoeller Z Control Apak 10-4013-A Instrucciones De Instalación página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.
Standing near the APak
, use your phone, tablet, or computer to look for the APak
®
"ZCTL_APAK_xxxx" where "xxxx" is the first 4 digits of your APak
1. The Z Control
LED will flash quickly.
®
2. A Z Control
setup screen will open after a few seconds.
®
If the setup screen does not appear, open a browser on the same device and type "zconfig.zoeller.com" or "192.168.125.1" in the address bar. If the
setup screen appears but is not used (cancelled or otherwise closed), the APak
next Wi-Fi
setup attempt.
®
Select the APak
3.
On the setup screen (see Figure J), press the "Wi-Fi
the APak
to use for internet connectivity. Enter the password for the router you chose in the field indicated. If the password is correct, the APak
®
connect to the router and start sending status updates to zcontrolcloud.com. You will see the Z Control
up to a minute or so.
If the LED does not turn solid, then the password entered is incorrect, the router's security is insufficient (see note below**), or some other network
restriction is in place (see your network administrator). The APak
force the APak
into AP mode again, either press the Silence button for 12 seconds OR hold the Silence button while applying AC power. Either of
®
these methods will cause the APak
Click Wi-Fi
®
**Note that the APak
will not connect to routers with "WEP" or "OPEN" security.
®
Figure I
's SSID
®
Scan" button, scroll down to see the list of Wi-Fi
®
to re-enter AP mode and begin transmitting its SSID again.
®
Figure J
Scan button
© Copyright 2018 Zoeller
's SSID in your Wi-Fi
®
's Device ID. Select this, and 2 things will happen:
®
will return to AP mode and the Z Control
®
will return to AP mode if the connection to router is not successful. If you need to
®
Co. All rights reserved.
®
5
settings (see Figure I). It will look like
®
LED will turn off until the
®
signals found, and choose the Wi-Fi
®
LED go from blinking to solid. This could take
®
Available Wi-Fi
will be listed
®
here. Select the one you want.
you want
®
will
®

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Z control apak 10-4014-a

Tabla de contenido