Attaching The Earmuffs (Optional); During Use; After Use; Cleaning And Disinfecting - Dräger X-plore 8000 Instrucciones De Uso

Ocultar thumbs Ver también para X-plore 8000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
4.1.3

Attaching the earmuffs (optional)

Illustration on the fold-out page (figure F)
1. Insert the earmuffs into the helmet adapter from below until they click into
place.
2. Adjust the earmuffs so that they cover the user's ears.
4.1.4
Donning the Dräger X-plore
WARNING
Danger through oxygen deficiency, CO
contaminants from the ambient air.
► Do not switch off respiratory protective device while the helmet is still
closed.
1. Fold up the visor.
2. Put the helmet on.
3. Hold the face cuff by the tabs and pull it apart.
4. Pull the face cuff under the chin so that it tightly encloses the face.
4.2

During use

WARNING
Risk of injury!
Danger through oxygen deficiency, CO
contaminants from the ambient air!
Full user protection only is guaranteed
► if the helmet fits in place optimally. The support ring must be adjusted to the
head circumference. Only wear the helmet when it is fully assembled and
ready for use (see "Checking serviceability", page 20).
► when the visor is locked into the lowest position (usage position).
► when the face cuff fits tightly on the face.
Instructions for use
|
Dräger X-plore 8000
®
8000 with visor
poisoning and penetration of
2
poisoning and penetration of
2
®
Helmet with Visor
4.3

After use

Perform the following activities after use:
WARNING
Danger through oxygen deficiency, CO
contaminants from the ambient air.
► Do not switch off respiratory protective device while the helmet is still
closed.
®
1. Take off the Dräger X-plore
8000 helmet with visor where the ambient air is
no longer contaminated.
®
2. Clean the Dräger X-plore
8000 helmet with visor (see chapter 4.1).
5
Maintenance
5.1

Cleaning and disinfecting

CAUTION
Potential damage to component parts!
► For cleaning and disinfecting only apply the described procedures and use
the specified cleaning agents and disinfectants. Other agents and
procedures, dosages and exposure times can damage component parts.
CAUTION
Health hazard!
The undiluted agents are damaging to health if they come into direct contact
with the eyes or skin.
► Wear goggles and protective gloves when working with these agents.
For information on suitable cleaning agents and disinfec-
tants and their specifications, see document 9100081 at
www.draeger.com/IFU.
Maintenance
poisoning and penetration of
2
|
en
19

Publicidad

Tabla de contenido
loading

Tabla de contenido