Limitations On Use; Explanation Of Type-Identifying Marking And Symbols; Nameplate - Dräger X-plore 8000 Instrucciones De Uso

en |
Description
3.4

Limitations on use

To make sure that enough clean air is available, the Dräger X-plore
helmet with visor must only be used in conjunction with the devices specified in
chapter 3.3 Intended use.
The protective effect can be impaired by the following factors:
– High wind velocities and strong crosswind
– Earpieces or beards under the face cuff
3.5 Approvals
The Dräger X-plore® 8000 helmet with visor conforms to the EU regulations on
personal protective equipment (EU) 2016/425. For information on the
corresponding system approvals please refer to the instructions for use of the
respirators mentioned in 3.3 Intended use.
The safety helmet is approved in accordance with the following standards:
– EN 397:2012+A1:2012
– EN 50365:2002
– ANSI ISEA Z89.1-2009
The visor is approved in accordance with the following standards:
– EN 166:2001
– ANSI ISEA Z87.1-2010
The earmuffs are approved in accordance with the following standards:
– EN 352-3:2002
– ANSI S3.19-1974
®
In the USA the Dräger X-plore 8000 helmet with visor is approved in
combination with the Dräger X-plore
accordance with Part 84, Title 42 of the Code of Federal Regulations. It is only
permitted to be used together with components that have NIOSH approval (see
Approval Label of the Dräger X-plore
16
®
8000
®
8000 powered air purifying respirator in
®
8000 blower unit).
3.6 Explanation of type-identifying marking and
symbols
3.6.1 Name plate
The illustrated name plate serves as an example. The specifications may vary
depending on the helmet.
X-plore 8000
Helmet with Visor, black
5
Part-No.: R58325
EN 12941
1
with Dräger Powered Air Purifying Respirator
4
Date of manufacture: XX/2014
1 Approval marking
2 Manufacturer
3 "Follow instructions for use"
symbol
Instructions for use |
Dräger X-plore 8000
1
Dräger Safety AG & Co. KGaA
2
23560 Lübeck, Germany
3
4 Date of manufacture (example)
5 Part number
®
Helmet with Visor