Listening To The Radio; Improving Fm Sound; Saving Station Presets; Listening To Station Presets - Pioneer AVSX-521-K Manual De Instrucciones

Basic playback
Refer to the Operating Instruction in CD-ROM for
instructions on how to connect and setup the Bluetooth
ADAPTER and how to play music.
®
The Bluetooth word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by PIONEER CORPORATION is under license. Other
trademarks and trade names are those of their respective
owners.

Listening to the radio

1
Press TUNER to select the tuner.
2
Use BAND to change the band (FM or AM), if necessary.
3
Tune to a station.
There are three ways to do this:
Automatic tuning
Press and hold TUNE / for about a second. The
receiver will start searching for the next station.
Manual tuning
To change the frequency one step at a time, press
TUNE /.
High speed tuning
Press and hold TUNE / for high speed tuning.
Release the button at the frequency you want.

Improving FM sound

If the TUNE or ST indicators don't light when tuning to an FM
station because the signal is weak, set the receiver to the
mono reception mode.
 Press BAND to select FM MONO.

Saving station presets

If you often listen to a particular radio station, it's convenient
to have the receiver store the frequency for easy recall
whenever you want to listen to that station.
1
Tune to a station you want to memorize.
See Listening to the radio above for more on this.
2
Press TUNER EDIT.
The display shows PRESET, then a blinking MEM and station
preset.
Press PRESET / to select the station preset you
3
want.
4
Press ENTER.
The preset number stop blinking and the receiver stores the
station.

Listening to station presets

You will need to have some presets stored to do this. See
Saving station presets above if you haven't done this already.
 Press PRESET / to select the station preset you
want.
© 2011 PIONEER CORPORATION.
All rights reserved.
19
En