Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
WARNING
Replace the power cord by an approved service center.
8.1
SPRAY TIP MAINTENANCE
17
11
If there is too much pump pressure, the spray tip can become
clogged, you can feel a pulsing sensation while you pull the
spray gun trigger.
8.1.1
REMOVE THE SPRAY TIP
1. Pull back the quick-connect collar on the spray wand (9).
2. Remove the spray tip from the spray wand (9).
8.1.2
CLEAN THE SPRAY TIP
1. Use a straight paper clip or cleaning tool (17) to clean the
spray tip.
2. Flush and clean the unwanted materials out of the spray
tip (11) with the garden hose (16).
3. Install the clean spray tip (11) to the spray wand (9).
9
TRANSPORTATION AND
STORAGE
WARNING
Disconnect the power cord and watter supply hose before
transportation and storage.
9.1
MOVE THE MACHINE
•
Point the spray wand in a safe direction.
English
•
Only hold the machine with the handgrip.
9.2
STORE THE MACHINE
Make sure that the spray gun, the high pressure hose and the
pump are dry.
Make sure the machine is out of the reach of children.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
•
Disconnect the garden hose from machine.
•
Wind the power cord and the high pressure hose.
•
Clean housing and the plastic components with a moist
and soft cloth.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
If needed, call the customer service phone number
(enter number here) for servicing instructions.
•
Store the machine in a dry, isolated and frost-free area.
10
TROUBLESHOOTING
PROBLEM
The motor does
not start.
11
WARNING
WARNING
NOTE
POSSIBLE
SOLUTION
CAUSE
The power button
Set the power
is in the "OFF"
switch to the
(O) position.
"ON" ( | ) posi-
tion.
The power cord is
Connect the power
not plugged in.
cord to the power
supply.
Electrical outlet
Try another elec-
does not supply
trical outlet.
sufficient power.
The circuit breaker
Let it cool, and
is tripped.
start the machine
again.
The power switch
Pull the spray gun
is on, but you do
trigger.
not pull the spray
gun trigger.
EN
Publicidad
Tabla de contenido
